Amico Light-Duty Monitor Arm Manuel d'utilisateur

Installation InstructionsLight-duty Monitor Arm (LMA) www.amico.com

10 Amico Accessories Inc.SECTION 3: Installation on Mounting PlatformMounting on the Desk: Clamp Mount AssemblyMounting on the Desk: Over Existing

www.amico.com 113. Remove the screw from the gripping plate as shown below.4. Insert the gripping plate into bolt and tighten into base pla

12 Amico Accessories Inc.SECTION 4: Device InstallationDevice Conguration Recommendations1. Determine the monitor conguration and if spacers ar

www.amico.com 13SECTION 4: Device InstallationCable Management

14 Amico Accessories Inc.SECTION 5: AdjustmentsAdjustment Procedure 11. Adjust the screw clockwise for heavier loads and counter-clockwise for li

www.amico.com 15SECTION 6: Maintenance and Troubleshooting Preventive MaintenanceWARNING LMA requires periodic inspection and maintenance t

16 Amico Accessories Inc.SECTION 6: Maintenance and Troubleshooting CleaningWARNING: The cleaning chemicals and methods below are not meant for

www.amico.com 17SECTION 7: Product ClassicationLMA - - -0101With 7" (177.8 mm) Extension02Without ExtensionDSK-SGr

Warranty PolicyAmico Accessories Inc. warrants all mounting accessories to be free from defects in material and workmanship for a period of twelve (12

www.amico.com 19Notes

2 Amico Accessories Inc.Preface IMPORTANT, PLEASE READ CAREFULLYThank you for your purchase with Amico Accessories Inc.This unit is designed for l

AAIMLMA 10.16.2014www.amico.comAmico Accessories Inc. | www.amico.com 85 Fulton Way, Richmond HillOntario, L4B 2N4, Canada71 East Industry Court, De

www.amico.com 3Contents Section 1: Product Specications 4 Section 2: Installation Preparation 5Section 3: Installation on Mounting Platform

4 Amico Accessories Inc.SECTION 1: Product SpecicationsFeatures• Ideal for applications where only occasional adjustment is needed• Available w

www.amico.com 5SECTION 2: Installation PreparationInstallation, Tools and Part Requirements• HEX key sizes: 2.5 mm; 1/8" (3.2 mm), 5 mm

6 Amico Accessories Inc.Mounting to MRS (Monitor Rail System):1. Assemble LMA to X-LMA-(MON/MON-B)-ADA by placing LMA onto X-LMA-(MON/MON-B)-ADA

www.amico.com 7Mounting to VRS (Vertical Rail System):1. Assemble LMA to X-LMA-(VRS/VRS-B)-ADA by placing LMA onto X-LMA-(VRS/VRS-B)-ADA and

8 Amico Accessories Inc.SECTION 3: Installation on Mounting PlatformMounting on the Wall1. Drill a 1/2" (12.7 mm) hole at the desired mounti

www.amico.com 91. Adjust the height of the desk clamp to suit desktop surface.2. Place the plastic gasket cushion as shown.3. Place the de